Full Face Gas Mask Flow Respirator Electric Supplied Air Fed Flow System Device. Performance: This reagent is capable of filtering and absorbing organic gases and vapors such as benzene, toluene, xylene, gasoline, kerosene, chlorine gas, acetone, alcohols, aniline, carbon disulfide, chloroform, bromomethane, nitro compounds, and more. Supplied fresh air respirator system is equipped with portable power source mainly overcome the problems of big air intaking resistance, difficulties in breathing and so on. This system use the air pump to transport the air to the mask. You could fix the air pump on your waist, so you are more close to the air source. The charging time is 3 hours and you could use it for 7 hours with the fully charged battery. The canister comes with the unit can filters a variety of harmful gas. Charging time: 3 hours. Working time: 7 hours. Charger Voltage: 110 V / 220 V. Air supply flow rate: First gear: 62 L/min Second gear: 74 L/min. Net weight of the air pump : 0.6 kg. 1 x air pump. 1 x full face mask. 2 x air pipe. 2 x canister filter. 1 x recharger. Before using the air supply fan, ensure that there is sufficient power and that it is operating normally. Before use, check all connections to ensure they are secure to prevent air leakage that may pose a health hazard to the user. Insert the appropriate length of the hose into the buckle on the safety belt at one end of the face mask. Tighten the belt to secure the long hose to the belt, preventing it from dragging and affecting the proper wearing of the mask. Check the airtightness of the entire system; seal the joint at the end of the air supply fan with your hand to block air intake. If you feel airtight, it indicates that the airtightness of the mask is good. Then insert the hose socket of the air supply fan and simultaneously start the fan to introduce fresh air into the mask for the user to breathe. After each use, wipe the mask, breathing tube, and accessories clean. Coil the long hose and place it in the storage box. The storage environment should be kept dry, ventilated, and away from heat. Avoid contact between the mask lens and organic solvents to prevent damage. Also, try to avoid collisions and friction to prevent scratching the lens surface. Men should shave their beards before wearing the mask to ensure a proper seal. The long hose mask should be stored by designated personnel and inspected regularly. Any issues discovered should be promptly repaired, and damaged components should be replaced as needed. If you detect any unusual odors or a lack of airflow during normal use, please check or replace the filter consumables promptly. When the following situations occur, work should be immediately stopped, and personnel should evacuate the site. Drowsiness due to harmful gases. Detection of the odor of harmful gases. Irritation of the eyes, nose, mouth, or other areas due to harmful gases. Abnormal air flow or cessation of air supply. Shutdown due to power outage, malfunction, or other reasons. This equipment is suitable for various dusty workplaces and is effective in preventing various particulate matter dust, mist, smoke, etc. And odors below permissible levels. It is not suitable for oxygen-deficient working environments (air environments with oxygen levels below 18%), IDLH concentrations (immediately dangerous to life and health), or workplaces where explosive conditions may occur. People Who Bought This Item Also Bought. Gas Mask Filter For Electric Constant Flow Supplied Air Fed Respirator System A.
